|
![](/i/fill.gif) |
Marc Champagne wrote:
> Xplo Eristotle <xpl### [at] infomagic net> wrote in
> news:3d756b77$1@news.povray.org:
>
>>I'm curious about the settings you used, particularly the
>>max_trace_level and the photons (since in both cases it appears you may
>>not be using high enough values).
>>
>>I would also guess that you may be using too much dispersion, as your
>>render is noticibly more rainbowy than the photo.
>
> global_settings {
> photons { spacing 0.08 count 5000 }
You need only specify a spacing or a count; they're essentially two
different ways to get the same effect. I don't know offhand what sort of
results spacing .08 would give, but count 5000 is far too low; try half
a million for good results.
> max_trace_level 60
60 should be plenty. Guess I was wrong about that.
> interior { ior 2.417 dispersion 1.044 dispersion_samples 30 }
I don't know proper values for diamond offhand, but these sound
plausible to me. I guess I was 1 for 3. Still, try increasing the number
of photons (and comment out dispersion for test renders!).
-Xplo
Post a reply to this message
|
![](/i/fill.gif) |